|
|
|
|
|
Andrej Atrens, Xingrui Chen and Zhiming Shi
Recent progress is reviewed. Recent developments include: (i) accumulation of evidence that electrochemical measurements of the Mg corrosion rate often do not agree with the steady state Mg corrosion rate as measured by weight loss; (ii) low Fe tolerance...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ramasis Goswami, Alex Moser, Ronald L. Holtz, Syed B. Qadri and Andrew Geltmacher
We address here an important issue related to sensitization effects in Al5083 by mitigating the grain boundary precipitation of the beta phase and demonstrate that the addition of a small amount of boron to Al5083 impedes the precipitation of the beta ph...
ver más
|
|
|
|
|
|
|
|
|
|
|
Peer Decker, Ines Zerbin, Luisa Marzoli and Marcel Rosefort
Two different intergranular corrosion tests were performed on EN AW-6016 sheet material, an ISO 11846:1995-based test with varying solution amounts and acid concentrations, and a standard test of an automotive company (PV1113, VW-Audi). The average inter...
ver más
|
|
|
|
|
|
|
|
|
|
|
Munsu Kim, Lorena Perez-Andrade, Luke N. Brewer and Gregory W. Kubacki
This paper investigates the effect of the microstructure on the corrosion behavior of cold sprayed (CS) AA5083 compared to its wrought counterpart. It has been shown that the microstructure of CS aluminum alloys, such as AA2024, AA6061, and AA7075, affec...
ver más
|
|
|
|
|
|
|
|
|
|
|
Henryk Kania and Anzelina Marek
Zn-Al-Mg-Si coatings are an excellent alternative to conventional hot-dip galvanizing coatings. Their high corrosion resistance in corrosive environments containing chlorides and CO2 is well recognized. But sulfur dioxide is also an important stimulator ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Qingli Ding, Hrishikesh Das, Piyush Upadhyay, Bryer C. Sousa, Kubra Karayagiz, Adam Powell and Brajendra Mishra
Friction stir welded (FSW) aluminum?magnesium lightweight vehicle joints have gained significant interest due to their high strength-to-weight ratio. In this work, the corrosion resistance of this material is analyzed through electrochemical tests, which...
ver más
|
|
|
|
|
|
|
|
|
|
|
Pi-Chen Lin, Kaifan Lin, Yu-Hsuan Lin, Kai-Chiang Yang, Vladimir Ivanovitch Semenov, Hsin-Chih Lin and Miin-Jang Chen
Polycrystalline HfZrO2 (HZO) film can be fabricated on as-extruded Mg?Ca alloy, which is identified by the results of XRD and TEM. HZO film can improve the corrosion resistance of as-extruded Mg?Ca alloy to further result in a decrease in the corrosion r...
ver más
|
|
|
|
|
|
|
|
|
|
|
Pingli Jiang, Carsten Blawert and Mikhail L. Zheludkevich
Magnesium alloys have shown great potential for applications as both structural and biomedical materials due to their high strength-to-weight ratio and good biodegradability and biocompatibility, respectively. Among them, Mg-Zn based alloys are attractin...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ai Serizawa, Takuhiro Oda, Kohei Watanabe, Kotaro Mori, Tetsuya Yokomizo and Takahiro Ishizaki
Al alloys offer excellent physical and mechanical properties, such as a low density, high specific strength, and good ductility. However, their low corrosion resistance has restricted their application in corrosive environments. There is a need, therefor...
ver más
|
|
|
|
|
|
|
|
|
|
|
Shahrouz Zamani Khalajabadi, Aminudin Bin Haji Abu, Norhayati Ahmad, Mohammed Rafiq Abdul Kadir, Ahmad Fauzi Ismail, Rozita Nasiri, Waseem Haider and Norizah Bt Hj Redzuan
In the field of orthopedics, magnesium (Mg) and magnesium-based composites as biodegradable materials have attracted fundamental research. However, the medical applications of magnesium implants have been restricted owing to their poor corrosion resistan...
ver más
|
|
|
|
|
|
|
|
|
|
|
Shahrouz Zamani Khalajabadi, Aminudin Bin Haji Abu, Norhayati Ahmad, Mohammed Rafiq Abdul Kadir, Ahmad Fauzi Ismail, Rozita Nasiri, Waseem Haider and Norizah Bt Hj Redzuan
In the field of orthopedics, magnesium (Mg) and magnesium-based composites as biodegradable materials have attracted fundamental research. However, the medical applications of magnesium implants have been restricted owing to their poor corrosion resistan...
ver más
|
|
|
|
|
|
|
|
|
|
|
András Kiss, Ricardo M. Souto, Géza Nagy
Pág. 11 - 14
Corrosion of Mg/Al alloy was investigated with the scanning electrochemical microscope (SECM) using a Mg2+ ion selective microelectrode (ISME) as measuring tip. Mg/Al alloys have practical application as sacrificial anodes to prevent the corrosion of var...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhaobin Liu, Jiaxin Li, Haoping Peng, Aijun Xie and Zhiwei Li
The effect of Mg addition on the microstructure and sacrificial anode protection performance of a hot-dip Al-5Zn-4Si-xMg coating was studied by scanning electron microscopy (SEM-EDS), an X-ray diffractometer, and an electrochemical workstation. The resul...
ver más
|
|
|
|
|
|
|
|
|
|
|
In-Kyu Choi, Soo-Ho Cho, Sung-Joon Kim, Yoo-Shin Jo and Sang-Ho Kim
The corrosion resistance of homogenized Al-Mg (6.5%) alloy?adding Si, Zn, Mn, and Fe (0.2%) to improve various properties?was observed. Differential scanning calorimetry (DSC) and a JMatPro simulation revealed that the optimal homogenization temperature ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Roya Malekkhouyan, Yoann Paint, Loïc Prince, Maurice Gonon and Marie-Georges Olivier
In the present study, Mg-Al layered double hydroxide (Mg-Al/LDH) was synthesized on the surface of AZ31 Mg alloy substrate via in-situ hydrothermal treatment. Synthesis parameters were changed to determine their effect on the lateral size of LDH. For thi...
ver más
|
|
|
|
|
|
|
|
|
|
|
Tongfang Liu, Song Rui and Sheng Li
|
|
|
|
|
|
|
|
|
|
|
Xiaochen Zhang, Jiaoxiang Wang, Chunyan Zhang, Bin Liu, Peng Jiang, Yang Zhao, Bateer Buhe, Tao Zhang, Guozhe Meng and Fuhui Wang
The formation process of LDHs (layered double hydroxides) coating on magnesium alloy by the CO2 pressurization method was studied. The micro-structure was observed by OM, SEM and GAXRD. The weighted gain curve, apparent activation energy, and CO2 solubil...
ver más
|
|
|
|
|
|
|
|
|
|
|
Sugrib Kumar Shaha, Siavash Borhan Dayani, Yuna Xue, Xin Pang and Hamid Jahed
In this paper, we report the application of zinc phosphate electrostatic-painting top coating on cold sprayed AA7075 leading to a significant improvement in corrosion-fatigue performance. High strength AA7075 powder was sprayed on AZ31B substrate, follow...
ver más
|
|
|
|
|
|
|
|
|
|
|
Xiaopeng Lu, Yan Chen, Carsten Blawert, Yan Li, Tao Zhang, Fuhui Wang, Karl Ulrich Kainer and Mikhail Zheludkevich
The influence of SiO2 particles on the microstructure, phase composition, corrosion and wear performance of plasma electrolytic oxidation (PEO) coatings on AM50 Mg was investigated. Different treatment durations were applied to fabricate coatings in an a...
ver más
|
|
|
|
|
|
|
|
|
|
|
Wei Chen, Dalu Zhang, Enlei Wang, Feng Yan, Lin Xiang and Zhiwen Xie
Detailed tests and characterizations were used to investigate the corrosion degradation behaviors of Ti6Al4V alloys in simulated marine environments. These alloys suffered from very slight pitting and a miniscule weight loss of 0.018 mg/cm2 during the 50...
ver más
|
|
|
|
|
|