|
|
|
Gisu Song, Hyounggil Park and Taegoo Lee
In order to design a safe shafting system in a ship, it is vital to precisely predict load on stern tube bearing. It is well known that load on stern tube bearing is directly influenced by the eccentric force of a propeller. In this paper, the effect of ...
ver más
|
|
|
|
|
|
|
Zhongyu Mao, Ran Tao, Funan Chen, Huili Bi, Jingwei Cao, Yongyao Luo, Honggang Fan and Zhengwei Wang
During the starting up of the pump mode in pump turbines, the axial hydraulic force acting on the runner would develop with the guide vane opening. It causes deformation and stress on the support bracket, main shaft and runner, which influence the operat...
ver más
|
|
|
|
|
|
|
Chih-Chiang Hong, Deng-Maw Tsai
Pág. 37 - 43
The present application related to a rotating arm type permanent magnet motor, in particular to a permanent magnet motor that was actuated by the action of the magnetic forces of a permanent magnet stator of a stator module and two thin ring permanent ma...
ver más
|
|
|
|
|
|
|
Yuan Zhou, Zian Ding, Dong Ding, Yue Xu, Xinchen Yang, Zongxu Li, Yuwei Cai and Shufa Sun
To decrease track derailment of tracked fire trucks in forested areas, a fish-bellied swing arm torsion bar suspension system is proposed in this research. Derived from a tracked forest fire engine, this study converts the shaft tube swing arm of the ori...
ver más
|
|
|
|
|
|
|
Miao-Miao Li, Liang-Liang Ma, Chuan-Guo Wu and Ru-Peng Zhu
Smart Spring is a kind of active vibration control device based on piezoelectric material, which can effectively suppress the vibration of the shaft system in an over-critical state, and the selection of control strategy has great influence on the vibrat...
ver más
|
|
|
|
|
|
|
Xinzhong Wang, Tianyu Hong, Weiquan Fang and Xingye Chen
The technology of plastic film mulching is widely applied in Xinjiang, but it also brings about serious issues of residual film pollution. Currently, the 1MSF-2.0 residual film recovery machine can effectively address the problem. However, it faces chall...
ver más
|
|
|
|
|
|
|
Yanzhong Wang, Delong Dou and Xiaoyan Dong
The non-return mechanism is the key device that plays the role of braking in the opening-and-closing electric actuator of an amphibious aircraft hatch door. The ball-and-socket contact pair, providing the pressing force, and the multi-disc friction pair,...
ver más
|
|
|
|
|
|
|
Weixin Zhou, Yao Zhao, Hua Yuan and Zhaoxin Ren
The unclear change laws of bearing offset and rotation, both of which influence the condition of shaft alignment during hull deformation, make it difficult to optimize shafting design. In this paper, an integrated hull-bearing-shaft model is designed and...
ver más
|
|
|
|
|
|
|
Jing Guo, Bo Xiao and Hongliang Ren
Force sensing in robotic-assisted minimally invasive surgery (RMIS) is crucial for performing dedicated surgical procedures, such as bilateral teleoperation and palpation. Due to the bio-compatibility and sterilization requirements, a specially designed ...
ver más
|
|
|
|
|
|
|
Dario Valentini, Giovanni Pace, Angelo Pasini, Ruzbeh Hadavandi and Luca D?Agostino
The paper presents an experimental campaign aimed at the characterization of the relationship between cavitation-induced instabilities and forces acting on the shaft, relevant to space application turbopumps. The experiments have been carried out on a si...
ver más
|
|
|
|
|
|
|
Kai Wang, Zheng Yang, Jianghao Guo, Yike Dang and Yuanling Yan
In this paper, a numerical simulation is used to establish a three-dimensional model, which considers the height of buildings, the relative position between buildings, and foundation pits. These were studied in detail to investigate the changes in settle...
ver más
|
|
|
|
|
|
|
Joon-Hwan Bae, Hyun-Duck Kwak, Sung-Jae Heo, Chang-Ho Choi and Jong-Soo Choi
Floating ring seals are widely used as a leakage control solution for turbomachines because they effectively operate with small clearances between the shaft and seal. The oxidizer pump of the 7 tonf liquid engine in the Korea Space Launch Vehicle II (KSL...
ver más
|
|
|
|
|
|
|
Jianmin Qiu, Ying Yang, Xin Hong, Piotr Vasiljev, Dalius Mazeika and Sergejus Borodinas
This paper presents a disc-type ultrasonic piezoelectric motor, which is designed for micro flying vehicles. It provides a high output rotation speed under low operating voltage, compared with common piezoelectric devices, by employing a ?contact teeth? ...
ver más
|
|
|
|
|
|
|
Volodymyr Blintsov,Hanna Hrudinina
Pág. 19 - 26
The research of nonlinear hydrodynamic characteristics of the propulsion and steering complex (PSC), which influence the accuracy of the plane trajectory motion of an autonomous underwater vehicle (AUV), is carried out. During the underwater vehicle curv...
ver más
|
|
|
|
|
|
|
Fabrizio Ortolani, Giulio Dubbioso, Roberto Muscari, Salvatore Mauro and Andrea Di Mascio
The understanding of the performance of a propeller in realistic operative conditions is nowadays a key issue for improving design techniques, guaranteeing safety and continuity of operation at sea, and reducing maintenance costs. In this paper, a summar...
ver más
|
|
|
|
|
|
|
Wei Chu, Yao Zhao, Ganbo Zhang and Hua Yuan
The longitudinal vibration of the propulsion shaft system is a challenging issue for marine noise management. We conducted various static and dynamic tests on our built test rig for the shafting system, presenting the results in this paper. By combining ...
ver más
|
|
|
|
|
|
|
Weixin Zhou, Yao Zhao, Hua Yuan, Jingxi Liu and Xiaoqiang Wang
The pressure distribution of a misaligned elastomeric journal bearing is crucial for analyzing the uneven excessive wearing of the propulsion shaft bearing. However, analysis of the misaligned bearing is usually mainly based on the finite element method ...
ver más
|
|
|
|
|
|
|
Shin-Pyo Choi, Jae-Ung Lee and Jun-Bum Park
The enlargement of ships has increased the relative hull deformation owing to draft changes. Moreover, design changes such as an increased propeller diameter and pitch changes have occurred to compensate for the reduction in the engine revolution and con...
ver más
|
|
|
|
|
|
|
Myeong-Ho Song, Taek-Kun Nam and Jae-ung Lee
The reliability of propulsion shafting systems is a major concern for ocean-going vessels because mid-ocean repairs can be time-consuming and spare parts must be available. To address this concern, vibration modeling and experimental measurements were co...
ver más
|
|
|
|
|
|
|
Jaehoon Jee, Chongmin Kim and Yanggon Kim
In order to cope with strengthened marine environmental regulations and to reduce fuel consumption, recently constructed vessels are equipped with an ultra-long stroke engine and apply engine de-rating technology. This was intended to improve propulsion ...
ver más
|
|
|
|