|
|
|
Xiaotian Niu and Jie Li
Reducing drag is critical to aircraft design. In recent years, laminar technology has become one of the most important feasible technologies for civil aircraft drag reduction design under many design constraints. However, various factors have a certain i...
ver más
|
|
|
|
|
|
|
Jang-oh Mo and Beom-seok Rho
Understanding the characteristics and effects of the laminar separation bubbles (LSBs) is important in the aerodynamic design of wind turbine airfoils for maximizing wind turbine efficiency. In the present study, numerical simulations using the ;...
ver más
|
|
|
|
|
|
|
Andreas Gross and Hermann F. Fasel
When a laminar boundary layer is subjected to an adverse pressure gradient, laminar separation bubbles can occur. At low Reynolds numbers, the bubble size can be substantial, and the aerodynamic performance can be reduced considerably. At higher Reynolds...
ver más
|
|
|
|
|
|
|
Yong Wang, Kongcheng Zuo, Peng Guo, Kun Zhao and Victor Feliksovich Kopiev
Reducing the tonal noise from airfoil instabilities has attracted significant interest from the aeronautical community in the past few years. The aim of this paper is to investigate the effect of structured porous trailing edges on the tonal noise reduct...
ver más
|
|
|
|
|
|
|
Matteo Dellacasagrande, Davide Lengani, Daniele Simoni and Marina Ubaldi
The bursting phenomenon consists in the switch of a laminar separation bubble from a short to a long configuration. In the former case, reduced effects on profile pressure distribution are typically observed with respect to the attached condition. On the...
ver más
|
|
|
|
|
|
|
Pedro Leite Ferreira and Dídia Isabel Cameira Covas
The current paper aims at assessing the effect of the radial mesh on the description of the axial velocity in steady-state and transient conditions and at presenting the results of a new optimized equal-area mesh. For this purpose, a quasi-2D model is im...
ver más
|
|
|
|
|
|
|
Amir Abdullaev, Alexander Kotvitskii, Ivan Moralev and Maxim Ustinov
Cancellation of the cross-flow vortices in a swept-wing boundary layer is attempted by plasma actuator array in numerical simulation. The response of the boundary layer to the stationary excitation by a single actuator section is measured experimentally ...
ver más
|
|
|
|
|
|
|
Yuanqiang Liu, Yan Liu, Zubi Ji, Yutian Wang and Jiakuan Xu
Surface suction provides an efficient way to delay boundary layer transitions. In order to verify the suction effects and determine the mechanism of suction control in transonic swept wing boundary layers, wind tunnel transition measurements in a hybrid ...
ver más
|
|
|
|
|
|
|
Lennart Lobitz, Hendrik Traub, Mats Overbeck, Maximilian Bien, Sebastian Heimbs, Christian Hühne, Jens Friedrichs and Peter Horst
Laminar flow offers significant potential for increasing the energy-efficiency of future transport aircraft. The German Cluster of Excellence SE2A is developing a new approach for hybrid laminar flow control. The concept aims to maintain laminar flow up ...
ver más
|
|
|
|
|
|
|
Milad Mohammadi and Mohammad Sadegh Abedinejad
A comprehensive investigation of turbulent combustion is accomplished to study the relationship between nitrogen oxide (NO) formation and entropy generation distribution in a non-premixed propane combustion. The radiation heat transfer and combustion are...
ver más
|
|
|
|
|
|
|
Mariana Montenegro-Montero, Gustavo Richmond-Navarro
Pág. 6 - 11
|
|
|
|
|
|
|
Muye Ge, Urban Svennberg and Rickard E. Bensow
Sheet cavitation inception can be influenced by laminar boundary layer flow separation under Reynolds numbers regimes with transitional flow. The lack of accurate prediction of laminar separation may lead to massive over-prediction of sheet cavitation un...
ver más
|
|
|
|
|
|
|
Atizaz Hassan, Rafiullah Khan, Numan Khan, Muhammad Aamir, Danil Yurievich Pimenov and Khaled Giasin
Composite materials are used in various industries such as marine, aircraft, automotive, etc. In marine applications, composites are exposed to seawater, which can affect their mechanical properties due to moisture absorption. This work focuses on the du...
ver más
|
|
|
|
|
|
|
Ettore Bertolini, Paul Pieringer and Wolfgang Sanz
The aim of this work is to study the influence of different subgrid-scale (SGS) closure models and inflow turbulence conditions on the boundary layer transition on the suction side of a highly loaded transonic turbine cascade in the presence of high free...
ver más
|
|
|
|
|
|
|
Valerio D?Alessandro, Sergio Montelpare and Renato Ricci
This paper present recent advances in the development of local correlation based laminar?to?turbulent transition modeling relying on the Spalart?Allmaras equation. Such models are extremely important for the flow regimes involved in wind energy applicati...
ver más
|
|
|
|
|
|
|
Daniel Gleichauf, Michael Sorg and Andreas Fischer
The evaluation of reduced laminar flow in the boundary layer of wind turbine rotor blades in operation introduced in this work enables estimations of wind turbine efficiency loss due to negative influence on the aerodynamic properties. This leads to a mo...
ver más
|
|
|
|
|
|
|
Florent Ravelet, Amélie Danlos, Farid Bakir, Kilian Croci, Sofiane Khelladi and Christophe Sarraf
The present study focuses on the inception, the growth, and the potential unsteady dynamics of attached vapor cavities into laminar separation bubbles. A viscous silicon oil has been used in a Venturi geometry to explore the flow for Reynolds numbers ran...
ver más
|
|
|
|
|
|
|
Judah Rutledge, Jesse J. French
Pág. 101 - 108
A water channel for performing flow visualization and studying scale models in fluid mechanics was designed, analyzed, and manufactured with commercially available components. The material cost of the channel is 10% of the leading educational units, and ...
ver más
|
|
|
|
|
|
|
Hoyeon Kim, Daehyeon Kim, Yonghee Lee and Haksung Kim
In order to evaluate the effects of soil box boundary conditions on the dynamic soil behavior, the Rigid Box (RB) and the Laminar Shear box (LSB) were constructed and 1 g shaking table tests were carried out for various boundary conditions. The boundary ...
ver más
|
|
|
|
|
|
|
Slawomir Kubacki, Daniele Simoni, Davide Lengani and Erik Dick
An algebraic intermittency model for boundary layer flow transition from laminar to turbulent state, is extended using an experimental data base on boundary layer flows with various transition types and results by large eddy simulation of transition in a...
ver más
|
|
|
|